Motionmart Supplier - Nippon Pulse Motor

Supplier Page - Nippon Pulse Motor

http://www.npm.co.jp/

STEPPER MOTORS, DRIVES & CONTROLLERS

A wide range of standard models is available. Nippon Pulse Motors, specialise in the customisation of motor specifications to match the customers' application requirements. Requests such as, attaching optional gear heads, connectors, pinions, and screw shafts etc., can all be accommodated via Micromechs’ superb customised product facility. Several magnet materials and winding resistances are available to present the ideal performance.

Size: 25, 35, 42, 55mm OD
Step Angle: 3.79K, 7.5K,15K
Optional Gearhead: 6/25, 1/5, 3/25, 1/10 , 2/25, 1/15, 1/25 . . . 1/300
Attachable Connector : JST, JAE, AMP, Molex
Customised Shaft : D-cut, Pinion-attached , Screw shaft

Hi-Pulse 3 is designed to match applications that require hi-speed and hi-power. We offer CDC series drivers for ease of start-up.

Maximum Speed: 5,000 rpm
Output Power: 30W, 50W, 100W, 200W,
Optional Gearhead: 1/3, 1/5, 1/9, 1/15, 1/25

We offer compact-size box type and card type driver units. Total 18 models are available for your selection. Driver chips are also offered for your own design.

3, 4, 5-phase / Bipolar and Unipolar
Constant voltage / Constant current
Over-current / Abnormal voltage detection
Auto-current down

Low cost chopping-current driver ICs enable you to design your own drive systems.

4-phase individual excitation input
TTL compatible input
Protection circuit for mis-operation

Our PTM Series synchronous motors are well suited for timing applications. With impedance protection, the shaft can be stalled continuously without danger of burning coil. Gear-attached types are also available for special use.

Voltage Range: AC24V`240V
Output Torque: 0.07 oz/-in(0.5g/cm) to 347 oz/in(25kg/cm)
Speed Variation: 600 RPM to 1Rev/day


Motors	Communication Chips	Motion Control Chips	Linear Motors