Trinamic Modules - PDF Catalogues

TMCM-170-57 Single axis BLDC servo controller/driver with encoder 10A/48V, motor mountable

Description

The TMCM-170 is a controller/driver module for high performance servo drives based on brushless DC motors and gives a high resolution like a stepper motor coupled with the high dynamic, high velocity and high reliability of a BLDC drive.
A built-in ramp generator allows parameterised smooth positioning, with an external switch in order to provide for an absolute position reference. Its small form factor allows direct mounting on or into a motor-encoder assembly and the TMCM-170 integrates a position regulator and a ramp generator, to allow for velocity modes.
The module can be remote controlled via an RS232, RS485 or via a CAN interface.

Specifications

Electrical data

• Coil current up to 10A (contact to cooling plane might be required using gap pad)
• Motor supply voltage 12V to 48V

Supported motors

• Three phase BLDC motors from a few watts up to 500W, optional hall effect sensors
• Two or three channel encoder attached to mechanical axis min 256 steps resolution.
• Velocity up to 100,000 rpm (el. field)

Interface

• CAN and RS232 or CAN and RS485
• Digital input for absolute position reference

Features

• Servo drive allows ultra precise and fast positioning
• Automatic positioning ramp generation with all parameters changeable on-the-fly
• Stand alone programme capability using TMCL 
• Different start-up modes for commutation
• Adaptable 256 entry 10 bit motor sine commutation table
• High efficiency, low power dissipation
• integrated protection: reverse polarity, overload/over-temperature

Software

• Stand-alone operation or remote controlled operation
• PC-based demonstration software allows setting of all parameters

Other

• Pluggable connectors for interface
• RoHS compliant
• Diameter: 61mm (two stacked PCBs)

 

 

Chilford Court, Rayne Rd, Braintree, Essex, CM7 2QS Tel: 01376 333303  Fax: 01376 551849 Copyright © 2012 Motionmart. All rights reserved.